Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

ignition lock. Turn the SmartKey to position 2 in the ignition lock.

overhead control panel that you have Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

as long as the transmitter button is being The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Adjusting the climate mode settings (AIR FLOW)
    This function is only available with 3-zone automatic climate control. The climate mode settings are especially effective at high temperatures. You can select the following climate mode settin ...

    Roadside Assistance button
      Press and hold Roadside Assistance button 1 for more than two seconds. This initiates a call to the Mercedes-Benz Customer Assistance Center. The indicator lamp in Roadside Assistance but ...

    Overview
    Outrageous proportions: a long bonnet, narrow-look windows with frameless side windows, dynamic roof sweeping back at an angle towards the rear. In 2003 the four-door Coupé was born: and th ...