Warning and display messages in the multifunction display

Activate ATTENTION ASSIST using the onboard

computer. Activate ATTENTION ASSIST using the onboard computer.

Symbol 1 appears in the multifunction display.

If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a break? message appears in the multifunction display.

Press  to confirm the message. If necessary, take a break.

On long journeys, take regular breaks in good Press On long journeys, take regular breaks in good to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:
• you switch off the engine.
• you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    See also:

    Important safety notes
    A license agreement must exist in order to activate the mbrace service. Ensure that your system is activated and ready for use, and press the MB Info call button to register. If any of the ...

    Cup holder in the rear seat armrest
    Do not sit on or support your body weight on the rear seat armrest when it is folded down, as you could otherwise damage it. Close the cup holder before folding the rear seat armrest up. ...

    Installing the towing eye
    Remove the towing eye from the vehicle tool kit. WARNING The exhaust tail pipe may be hot. You could burn yourself if you touch the tail pipe. Be particularly careful when removing the rear ...