High-beam spot lamp (vehicles with halogen daytime running lamps)
Switch off the lights.
Open the hood.
Turn housing cover 1 counter-clockwise
and pull it out.
Turn bulb holder 2 counter-clockwise and
pull it out.
Take the bulb out of bulb holder 2.
Insert the new bulb into bulb holder 2.
Insert bulb holder 2.
Left-hand headlamp: cable outlet 3 must be pointing up and to the right.
Right-hand headlamp: cable outlet 3 must be pointing down and to the left.
Turn bulb holder 2 clockwise.
Handle 4 of bulb holder 2 is horizontal.
Align housing cover 1 and turn it
clockwise until it engages.
See also:
Limited Warranty
Follow the instructions in this manual
about the proper operation of your vehicle
as well as about possible vehicle damage.
Damage to your vehicle that arises from
culpable contraventions again ...
Important notes on tire pressure
WARNING
Should the tire pressure drop repeatedly:
• check the tire for foreign bodies.
• check whether the wheel is losing air or the valve is leaking.
• make sure that only a valve cap approved ...
Calibrating the compass
Make sure that there is sufficient space for you to drive in a circle
without impeding the remaining traffic.
In order to calibrate the compass correctly, observe the following points:
ca ...