Transferring data to another system (vehicle)

card or USB stick) with the saved data into/ Insert/connect the storage medium (SD card or USB stick) with the saved data into/ to the relevant interface.

turning the COMAND controller and Select Vehicle in the main function bar by turning press to confirm. the COMAND controller and press The "Vehicle" menu appears. to confirm.

The "Vehicle" menu appears.

confirm. Select System and press confirm. to confirm.

to confirm. Select Upload/Download Data and press Select Import Data from Storage to confirm.

Medium and press to confirm. Select Import Data from Storage Medium and press Select Start Data Import. to confirm.

A prompt appears, asking whether the Select Start Data Import.

A prompt appears, asking whether the COMAND data should be overwritten.

COMAND should be overwritten. Press Yes to confirm that the data saved in COMAND should be overwritten.

COMAND imports the data and restarts the system.

or

Lights and windshield wipers Press No to cancel the import process.

    See also:

    Correct use
    Observe the following information when using COMAND: • the safety notes in this manual • all road traffic regulations Work improperly carried out on electronic components or systems (e.g. ...

    Function restrictions
    For safety reasons, some COMAND functions are restricted or unavailable while the vehicle is in motion. You will notice this, for example, because you will either not be able to select certain ...

    Setting the rear-compartment air vents
    Setting the center vents in the rear compartment 1. Rear-compartment air vent thumbwheel 2. Rear-compartment air vent, right 3. Rear control panel for automatic climate control 4. R ...