Switching locator lighting on/off
If you switch on the locator lighting, the
following come on in the dark after you have
unlocked the vehicle using the remote
control:
• the parking lamps
• the tail lamps
• the license plate lamp
• the front fog lamps
• the entry lamps in the exterior mirror
The locator lighting switches off again when you open the driver’s door. If you do not open the driver’s door, the locator lighting switches off automatically after 40 seconds.

To switch locator lighting on/off: select
Vehicle in the main function bar by sliding
and turning
the COMAND
controller and press
to confirm.
The main area is active.
Select the Locator Lighting function by
sliding
or turning
the COMAND
controller and press
to confirm.
See also:
MOExtended tires (tires with run-flat
properties)
MOExtended tires (tires with run-flat
properties) allow you to continue driving your
vehicle even if one or more tires are entirely
deflated.
MOExtended tires may only be used in
conjunction ...
Important safety notes
WARNING
When operating the climate control, the air
that enters the passenger compartment
through the air vents can be very hot or very
cold (depending on the set temperature). This
could c ...
Introduction
You can establish a Bluetooth® connection to the audio system or to COMAND (see
the separate operating instructions).
WARNING
A driver's attention to the road must always be his/her prima ...
