Operation with an active COMAND source
You can transfer an audio or video mode selected in COMAND to the Rear Seat Entertainment System.
If you subsequently switch modes in
COMAND, the new source will not be
transmitted to the Rear Seat Entertainment
System.
To switch on the function in COMAND:
switch on the desired audio mode in
COMAND or show the menu in video DVD
mode.
Select the menu item at the bottom left,
e.g. CD in audio CD mode, by sliding
and turning 
the COMAND controller
and press 
to confirm.
Select Active Source for Rear and
press 
to confirm.
In the status bar at the top, you will see the
headphones icon and the 
icon for
the
source that has been switched on.
To switch off the function in COMAND:
switch on the desired audio mode in
COMAND or show the menu in video DVD
mode.
Select the menu item at the bottom left,
e.g. CD in audio CD mode, by sliding
and turning 
the COMAND controller
and press 
to confirm.
Select Rear OFF
and press
the
COMAND controller to confirm.
See also:
Reporting malfunctions relevant to safety
For the USA only:
The following text is reproduced as required of all manufacturers according to
Title 49, Code of U.S. Federal Regulations, Part 575 pursuant to the National Traffic
and Motor Ve ...
Components and storage
The EASY-PACK load-securing kit allows you
to use your cargo compartment for a variety
of purposes. The accessory parts are located
under the trunk floor.
– Open the trunk floor.
EASY-PACK ...
ESP® trailer stabilization
If your vehicle with trailer (vehicle/trailer
combination) begins to lurch, you can only
stabilize the vehicle/trailer combination by
depressing the brake firmly.
In this situation, ESP® assist ...