Selecting a destination from the destination memory (e.g. My address)
Introduction
The destination memory always contains an entry named "My address". You may wish to assign your home address to this entry, for example, and select it for route guidance. This entry is always located at the top of the list in the destination memory.
To activate navigation mode: press the
function button once or twice.
To show the menu: press 
the COMAND
controller.
Select Destination in the navigation
system menu bar by turning 
the
COMAND controller and pressing to
confirm.
Select From Memory and press
to
confirm.
Select My Address by turning
the
COMAND controller.
Irrespective of the option, press
to
confirm your selection.
"My address" has been entered.
To start route calculation: select Start
and press to confirm.
See also:
Important safety notes
WARNING
For safety reasons, switch off the windshield
wipers and remove the key from the ignition
lock before changing the wiper blades
(vehicles with KEYLESS-GO: make sure that
the on-boar ...
Problems with the SmartKey
Problem
Possible causes/consequences and
Solutions
You cannot lock or unlock the vehicle using the
SmartKey.
The SmartKey battery is discharged or nearly discharged.
- ...
Important safety notes
Your vehicle may be equipped with a sliding
sunroof or a panorama roof with power tilt/sliding panel. In the following
section, the
term "sliding sunroof" refers to both types of
sli ...