Reset function
You can reset COMAND to the factory settings. Amongst other things, this will delete all personal data (e.g. station presets, address book entries, entries in the destination memory and in the list of previous destinations in the navigation system).
Resetting is recommended before selling or transferring ownership of your vehicle, for example.
Select Vehicle in the main function bar by
turning 
the COMAND controller and
press 
to confirm.
Select System by turning
the
COMAND controller and press to
confirm.
Select Reset and press to
confirm.
A prompt appears asking whether you wish
to reset.
Select Yes or No and press to
confirm.
If you select No, the process will be aborted.
If you select Yes, another prompt appears
asking whether you really wish to reset.
Select Yes or No and press to
confirm.
If you select Yes, a message will be shown.
COMAND is reset and restarted.
If you select No, the process will be aborted.
See also:
Load index
Tire data is vehicle-specific and may
deviate from the data in the example.
In addition to the load bearing index, load
index 1 may be imprinted after the letters
that identify speed index 6 ...
Cross bar
Points to observe before use
The maximum roof load that can be used with
additional accessories decreases by the dead
weight of the crossbars (13.7 lbs/6.2 kg).
Note that installing the crossb ...
Problems with PARKTRONIC
Problem
Possible causes/consequences and - Solutions
Only the red segments
in the PARKTRONIC
warning displays are lit.
You also hear a warning
tone for approximately ...