Mute

Switching audio and video sources on/off

multifunction Press the multifunction button on the multifunction steering wheel.
The sound from the respective audio or video source is switched on or muted.

displays the symbol in the status When the sound is off, the system displays the line. symbol in the status line.
When you change the audio or video source, or adjust the volume, sound automatically switches on again.

still hear traffic and navigation system Even if the sound is switched off, you will still hear traffic and navigation system announcements.

Switching off Traffic program and navigation announcements completely

button Traffic program: press the until the message disappears from button until the the message disappears from the status bar of the display.
A confirmation tone sounds.
announcement, press the button on Navigation announcements: during an announcement, press the the multifunction steering wheel. button on the multifunction steering wheel.

Switching Traffic program and navigation announcements on again

button until the Traffic program: press and hold down the display appears button until the in the status bar. display appears in the status bar.
A confirmation tone sounds.
symbol in the navigation menu bar and Navigation messages: select the symbol in the navigation menu bar and symbol in the navigation menu bar and press The navigation announcements are to confirm.

activated again if you switch COMAND off The navigation announcements are activated again if you switch COMAND off and on again or start a new route guidance.

    See also:

    Setting a speed
    WARNING Keep in mind that it may take a brief moment until the vehicle has made the necessary adjustments. Increase or decrease the set vehicle speed to a value that the prevailing road co ...

    Rear fog lamp
    To switch on the rear fog lamp: turn the SmartKey in the ignition lock to position 2 or start the engine. Turn the light switch to or (vehicles with front fog lamps), or turn the light s ...

    Storing a phone number which has not yet been stored
    Introduction For incoming calls from a person who is not in the address book, COMAND displays the phone number in the call list. You can save this entry. Storing as a new entry in the address ...