Resetting the panorama roof with power tilt/sliding panel or the front roller sunblind
Reset the panorama roof with power tilt/sliding panel or the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
Do not open the panorama roof with power tilt/sliding panel until it has been reset correctly. The panorama roof with power tilt/sliding panel can otherwise be locked in the open position.
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Pull the switch repeatedly to the
point
of resistance in the direction of arrow
3 until the panorama roof with
power tilt/sliding panel is fully closed.
Keep the switch pulled for an
additional second.
Pull the switch in the direction
of
arrow 3 repeatedly until the
front roller sunblind is closed.
Keep the switch pulled for an
additional second.
Make sure that the panorama roof with
power tilt/sliding panel and the
front roller sunblind can be fully
opened again.
If this is not the case, repeat the steps
above again.
See also:
Setting the center air vents
1. Center air vent, left
2. Center air vent, right
3. Center vent thumbwheel, right
4. Center vent thumbwheel, left
•► To open/close: turn thumbwheels 3
and 4 up or down. ...
Compass
Calling up the compassInformation on operating the compass can be
found in the separate COMAND operating
instructions. ...
Storing the current speed or calling up
a stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising from ...