Opening and closing
You can continue to operate the sliding
sunroof after switching off the engine or
removing the SmartKey from the ignition
lock. This function is available for up to five
minutes or until the driver's or frontpassenger
door is opened.

Overhead control panel
1 To raise
2 To open
3 To close/lower
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Press or pull the
switch in the
corresponding direction.
If you press the
switch beyond
the
point of resistance, an automatic opening/closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
When raising the roof, automatic operation
is only available if the sliding sunroof is in
the closed position.
When opening the roof, automatic
operation is only available if the sliding
sunroof is not raised.
The sun protection cover automatically opens along with the sliding sunroof. You can open or close the sun protection cover manually when the sliding sunroof is raised or closed.
See also:
Making adjustments in 5 mph (Canada: 10 km/h) increments
•► Briefly press the cruise control lever beyond the pressure point, up 1 for a higher speed or down 2 for a lower speed.
The last speed stored is increased or reduced. ...
Removing the mechanical key
Push release catch 1 in the direction of the arrow and at the same time,
remove mechanical key 2 from the SmartKey.
...
Downloading destinations in COMAND
Information on the components
and
operating principles of COMAND can be
found in the separate COMAND operating
instructions.
You can only use the Destination
Download function if the vehi ...
