Restarting the tire pressure monitor

WARNING
It is the driver's responsibility to set the tire pressure to the recommended cold tire pressure. Underinflated tires affect the ability to steer or brake the vehicle. You might lose control over the vehicle.

When you restart the tire pressure monitor, all existing warning messages are deleted and the warning lamps go out. The monitor uses the currently set tire pressures as the reference values for monitoring.

The tire pressure monitor must be restarted when you set the tire pressure to a new value (as a result of changed drive or load characteristics, for example). The tire pressure monitor then monitors the new tire pressure values.

Canada only: in most cases, the tire pressure monitor recognizes the new reference values automatically. However, you can also define reference values manually as described here.

Restart the tire pressure monitor after you have set the tire pressure to the value recommended for the desired driving situation. Only correct tire pressures on cold tires. Comply with the recommended tire pressures on the Tire and Loading Information placard on the B-pillar on the driver's side. Additional tire pressure values for driving at high speeds or with heavy loads can be found in the tire pressure table on the inside of the fuel filler flap.

•► Make sure that the tire pressure is correct on all four wheels.

•► Make sure that the SmartKey is in position 2 in the ignition lock.

•► Press the steering wheel to select the Serv. menu. button on the steering wheel to select the Serv. menu.

•► Press the Tire Pressure. button to select Tire Pressure.

•► Press the The multifunction display shows the button.

The multifunction display shows the current tire pressure of the individual tires or the Tire pressures will be displayed after driving a few minutes message

•► Press the The Use Current Pressures as New button.

The Use Current Pressures as New Reference Values message appears in the multifunction display.

If you wish to confirm the restart:

•► Press the The Tire Press. Monitor Restarted button.

The Tire Press. Monitor Restarted message appears in the multifunction display.

After driving for a few minutes, the system checks whether the current tire pressures are within the specified range. The new tire pressures are then accepted as reference values and monitored.

If you wish to cancel the restart:

•► Press the The tire pressure values stored at the last button.

The tire pressure values stored at the last restart will continue to be monitored.

    See also:

    Change of direction announced without a lane recommendation
    1. Road into which the change of direction leads 2. Distance to change of direction and visual distance display 3. Current road 4. Symbol for change of direction When a change of di ...

    Problems with the seat heating
    The seat heating has switched off prematurely or cannot be switched on. The vehicle's electrical system voltage is too low because too many electrical consumers are switched on. - Switch off ...

    Active light function
    The active light function is a system that moves the headlamps according to the steering movements of the front wheels. In this way, relevant areas remain illuminated while driving. This allows ...