Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
•► Turn the SmartKey to position 2 in the ignition lock.
•► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
See also:
Switching on/off
The three red indicator lamps in the button
indicate the heating level you have selected.
If the battery voltage is too low, the seat
heating may switch off.
One or more of the indicator lamp ...
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
operated ten times while the lights are on and
the engine is running. ...
Restricting the shift range
Pull the left-hand steering wheel paddle
shifter.
The automatic transmission shifts down
one gear and restricts the shift range to the
relevant gear.
If the engine exceeds the maximum
engi ...