Warning and display messages in the multifunction display
•► Activate ATTENTION ASSIST using the onboard computer
Symbol 1 appears in the multifunction display.
If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a rest? message appears in the multifunction display.
•► If necessary, take a break.
•► Press 
to confirm the message.
On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.
ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:
- you switch off the engine.
- you take off your seat belt and open the
driver's door, e.g. for a change of drivers or
to take a break.
See also:
Important safety notes
WARNING
Always remember that you must concentrate
primarily on driving the vehicle. The driver's
concentration must always be directed
primarily at road traffic. For your own safety
and that ...
Seat belts
Display messages
After starting the
engine, the red seat
belt warning lamp lights
up for six seconds.
Possible causes/consequences and ►
Solutions
The seat belt warning lamp reminds the ...
Adjusting the four-way lumbarsupport
You can adjust the contour of the driver's seat
backrests individually to provide optimum
support for your back.
1 To raise the backrest contour
2 To soften the backrest contour
3 To lower the ...