Engaging park position P
•► Push the DIRECT SELECT lever in the direction of arrow P.
The automatic transmission shifts automatically into park position P if you open the driver's door when the vehicle is stationary or driving at very low speed, and the transmission is in position D or R. This function depends on the date of manufacture of your vehicle.
If the engine speed is too high or the vehicle is moving, do not shift the automatic transmission directly from D to R, from R to D or directly to P. The automatic transmission could otherwise be damaged.
HOLD function or DISTRONIC PLUS: the automatic transmission automatically switches to transmission position P if the vehicle is braked by the HOLD function or DISTRONIC PLUS. In addition, at least one of the following conditions must be fulfilled:
- the engine is switched off.
- the driver's door is open and the seat belt
is not in the buckle.
See also:
Setting the temperature in the rear
compartment using the front control
panel
Turn the SmartKey to position 2 in the
ignition lock.
Activate the rear compartment
function via COMAND.
The rear-compartment climate control can
be controlled via the front control panel
...
General information
Do not exceed the legally prescribed maximum speed for vehicle/trailer
combinations in the relevant country. This lowers the risk of an accident.
Only install an approved trailer coupling on y ...
Switching on/off
The three blue indicator lamps in the buttons
indicate the ventilation level you have
selected.
If the battery voltage is too
low, the seat
ventilation may switch off.
- Make sure that ...