Notes on using 3-zone automatic climate control
The following contains instructions and recommendations to enable you to get the most out of your automatic climate control.
- Activate climate control using the
and
buttons. The indicator lamps above
the
and
buttons light up. You
can also set the airflow and air distribution
of the automatic climate control to one of
three levels (FOCUS/MEDIUM/DIFFUSE).
You can set the desired level using button 11. The MEDIUM level is recommended.
- Set the temperature to 72 °F (22 °C).
- Only use the "defrosting" function briefly until the windshield is clear again.
- Only use "air-recirculation" mode briefly, e.g. if there are unpleasant outside odors or when in a tunnel. The windows could otherwise fog up as, in air-recirculation mode, no fresh air is drawn into the vehicle.
- Use the ZONE function to adopt the
temperature settings on the driver's side
for the front-passenger side and the rear
compartment as well. The indicator lamp
above the
button goes out.
- Use the residual heat function if you want to heat or ventilate the vehicle interior when the ignition is switched off. The "residual heat" function can only be activated or deactivated with the ignition switched off.
See also:
Hill start assist
Hill start assist helps you when pulling away forwards or in reverse on an uphill
gradient. It holds the vehicle for a short time after you have removed your foot
from the brake pedal. This gives ...
Charging the battery
WARNING
Never charge a battery still installed in the vehicle unless
a battery charger unit approved by Mercedes-Benz is being used. Gases may escape
during charging and cause explosions tha ...
Suspension tuning
The electronically controlled ABC suspension
system works continuously. This improves
driving safety and comfort.
The ABC suspension system is tuned
individually to each wheel and depends on:
...
