Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/ sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
•► Turn the SmartKey to position 1 or 2 in the ignition lock.
•► Pull the 
switch repeatedly to the
point
of resistance in the direction of arrow 3
until the panorama roof with power tilt/
sliding panel is fully closed.
•► Keep the switch pulled for an
additional second.
•► Pull the switch repeatedly to
the point
of resistance in the direction of arrow 3
until the roller sunblinds are fully closed.
•► Keep the switch pulled for an
additional second.
•► Make sure that the panorama roof with power tilt/sliding panel and the roller sunblinds can be fully opened again.
•► If this is not the case, repeat the steps above again.
If the panorama roof with power tilt/ sliding panel and the roller sunblind cannot be fully opened or closed after resetting, contact a qualified specialist workshop.
See also:
System self-test
After you have switched on the ignition, the
system carries out a self-diagnosis.
WARNING
A malfunction in the system has been
detected if one of the following conditions
occurs:
- ...
Service menu
In the Service menu you can:
• call up display messages
• check the tire pressure electronically
• call up the service due date
• check the oil level ...
Making adjustments in 1 mph (Canada:1 km/h) increments
► Briefly press the cruise control lever
to the
pressure point, up 1 for a higher speed or
down 2 for a lower speed.
The last speed stored is increased or
reduced. ...