Opening and closing

Overhead control panel

Overhead control panel

1. To raise
2. To open
3. To close/lower

The panorama roof with power tilt/sliding panel can only be operated when the roller sunblind is open.

•► Turn the SmartKey to position 1 or 2 in the ignition lock.

•► Push or pull the corresponding direction. switch in the corresponding direction.

If you press the the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Overview: changing bulbs/bulb types
    You can change the following bulbs. The bulb type can be found in the legend. Halogen headlamps Turn signal lamp/side marker lamp: WY 5 W Turn signal lamp: PY 21 W High-beam headlamp: H7 55 ...

    Trip computer "From start" or "From reset"
    The values in the From Start submenu are calculated from the start of a journey, while the values in the From Reset submenu are calculated from the last time the submenu was reset. Press the ...

    Important safety notes
    WARNING   Grains of sand, particles of dirt and other abrasive materials can enter the brake system. This can lead to excessive wear and unpredictable braking efficiency. After the bra ...