ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the alarm system is armed and you open:
- a door
- the vehicle with the mechanical key
- the trunk lid/tailgate
- the hood
The alarm is not switched off, even if you close the open door that has triggered it, for example.
If the alarm stays on for more than 30 seconds, the emergency call system mbrace (USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance Center automatically. The emergency call system initiates the call provided that:
- you have subscribed to the mbrace/
TELE AID service.
- the mbrace/TELE AID service has been
activated properly.
- the required mobile phone, power supply
and GPS are available.
•► To arm: lock the vehicle with the SmartKey or KEYLESS-GO.
Indicator lamp 1 flashes. The alarm system is armed after approximately 15 seconds.
•► To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
•► To stop the alarm using the SmartKey: insert the SmartKey into the ignition lock.
The alarm is switched off.
or
•► Press the 
or
button on the
SmartKey.
The alarm is switched off.
•► To stop the alarm using KEYLESS-GO: grasp the outside door handle. The SmartKey must be outside the vehicle.
The alarm is switched off.
or
•► Press the Start/Stop button on the
dashboard. The SmartKey must be inside
the vehicle.
The alarm is switched off.
See also:
Limited braking performance on salttreated roads
WARNING
The layer of salt on the brake discs and the
brake pads/linings may cause a delay in the
braking effect, resulting in a significantly
longer braking distance, which could lead to
an ...
Low-beam headlamps
► To switch on the low-beam headlamps:
turn the SmartKey in the ignition lock to
position 2 or start the engine.
► Turn the light switch to
.
The indicator lamp in the
instru ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences ...