Seat belt adjustment
The seat-belt adjustment function adjusts the driver's and front-passenger seat belt to the upper body of the occupants.
The belt strap is tightened slightly when:
- you engage the belt tongue in the belt
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
- the SmartKey is in position 2 in the ignition
lock and you then engage the belt tongue
in the buckle.
The seat-belt adjustment will apply a retraction force if any slack is detected between the occupant and the seat belt. Do not hold on to the seat belt tightly while it is adjusting. You can switch the seat-belt adjustment on and off in the on-board computer.
The seat-belt adjustment is an integral part of the PRE-SAFE® convenience function. More information about PRE-SAFE® can be found in the "PRE-SAFE® (preventative occupant protection)" section.
See also:
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...
Preparing the vehicle
Your vehicle may be equipped with a
"Minispare" emergency spare wheel or
MOExtended tires (tires with run-flat
properties).
Vehicle preparation is not necessary on
vehicles with MOEx ...
Selecting a folder
This function is only available in MP3 mode.
Switch on MP3 mode.
Select Search by sliding and
turning
the COMAND controller and press
to confirm.
Select Folder by sliding and
turning ...