Fuse box in the engine compartment

turned off.  Make sure that the windshield wipers are turned off.

WARNING
Make sure that the windshield wipers are switched off and that the SmartKey is removed from the ignition lock before you open the cover of the fuse box. Otherwise, the windshield wipers and the wiper rods above the cover could be set in motion. This could lead to you or others being injured by the wiper rods.

  Open the hood.

  Remove any existing moisture from the

fuse box using a dry cloth.  Remove any existing moisture from the fuse box using a dry cloth.
  To open: open clamps 1.  Take lines 2 from the guides.
  Remove the fuse box cover forwards.  To open: open clamps 1.
Make sure that no moisture can  Remove the fuse box cover forwards.

enter the Make sure that no moisture can enter the fuse box when the cover is open.

lying correctly in the cover.  To close: check whether the rubber seal is lying correctly in the cover.
into the retainer.  Insert the cover at the rear of the fuse box into the retainer.
  Secure lines 2 in the guides.  Fold down the cover and close clamps 1.
The cover must be seated  Secure lines 2 in the guides.

properly, The cover must be seated properly, otherwise moisture or dirt could impair the function of the fuses.

Fuse box in the trunk  Close the hood.

    See also:

    Transporting the vehicle
    The towing eye can be used to pull the vehicle onto a trailer or transporter for transporting purposes. •► Turn the SmartKey to position 2 in the ignition lock. •► Shift the automa ...

    Belt warning for the driver and front passenger
    Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if t ...

    Parking lamps/standing lamps (halogen headlamps)
    •► Switch off the lights. •► Open the hood. •► Turn housing cover 1 counter-clockwise and pull it out. •► Pull out bulb holder 2. •► Take the bulb out of bulb hol ...