Points to observe before use
The sockets can be used for accessories, e.g.
lamps or mobile phone chargers with a maximum current draw of 180 W (15 A).
If you use the sockets for long periods when the engine is switched off, the battery may discharge.
Turn the SmartKey to position 1
in the
ignition lock.
An emergency cut-out ensures
that the
on-board voltage does not drop too low. If
the on-board voltage is too low, the power
to the sockets is automatically cut. This
ensures that there is sufficient power to
start the engine.
See also:
Calling up a stored setting
If you want to move the seat from the fully reclined position to a stored seat
position, first raise the backrest. The seat could otherwise be damaged.
Press and hold the relevant storage positi ...
Replacing the windshield wiper blades
Removing the wiper blades
Remove the SmartKey from the
ignition lock or turn it to position 0 (KEYLESS-GO).
Fold the wiper arm away from the
windshield until it engages.
Set the wiper blade ...
Storing the current speed or calling up the last stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising from r ...
