Activating the rear view camera

in position 2 in the ignition lock. Make sure that the SmartKey is in position 2 in the ignition lock.
camera" function is selected in COMAND (see the separate operating instructions Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for COMAND).
The area behind the vehicle is shown in the COMAND display. Engage reverse gear.
The area behind the vehicle is shown in the COMAND display.

    See also:

    Power, Eventually
    Weighing more than 4,600 pounds, our all-wheel-drive test car was heavier than many large crossovers. But its engine — a 5.5-liter V-8 good for 382 horsepower and an impressive 391 pounds-feet of ...

    Useful information
    This Operator's Manual describes all models and all standard and optional equipment of your vehicle available at the time of publication of the Operator's Manual. Country-specific differe ...

    Important safety notes
    WARNING It is dangerous to shift the automatic transmission out of parking position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly on the ...