Activating/deactivating the residual heat function

The residual heat function is only available in vehicles for Canada with automatic climate control.

It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.

speed The blower will run at a low speed regardless of the airflow setting.

heat function If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.

0 in the ignition lock or remove it. Turn the SmartKey to position 0 in the ignition lock or remove it.
button. To activate: press the The indicator lamp in the button button.
The indicator lamp in the lights up. button lights up.
button. To switch off: press the The indicator lamp in the button button.
The indicator lamp in the goes out. button goes out.

automatically: Residual heat is deactivated automatically:
• after about 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low

    See also:

    Call priority
    When service calls are active, e.g. Roadside Assistance or MB Info calls, an emergency call can still be initiated. In this case, an emergency call will take priority and override all other active ...

    Removing the ball coupling
    Observe the manufacturer's installation instructions. Press the protective cap into the ball coupling recess. Make sure that the protective cap is firmly in place. ...

    Adjusting the head restraint height(second and third row of seats)
    Outer seat head restraints in the second row of seats Outer seat head restraints in the third row of seats ► If the head restraint is fully lowered, it is necessary to press release ...