Other bulbs
There are bulbs other than the Xenon bulbs that you cannot replace. Replace only the bulbs listed. Have the bulbs that you cannot replace yourself changed at a qualified specialist workshop.
Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose. In particular, work relevant to safety or on safety-related systems must be carried out at a qualified specialist workshop.
If you require assistance changing bulbs, consult a qualified specialist workshop.
Do not touch the glass tube of new bulbs with your bare hands. Even minor contamination can burn into the glass surface and reduce the service life of the bulbs. Always use a lintfree cloth or only touch the base of the bulb when installing.
Only use bulbs of the correct type.
If the new bulb still does not light up, consult a qualified specialist workshop.
Bulbs and lamps are an important aspect of vehicle safety. You must therefore make sure that these function correctly at all times.
Have the headlamp setting checked regularly.
WARNING
Bulbs and lamps can be very hot. You should
therefore allow them to cool down before you
change them. Otherwise, you could be burned
if you touch them.
Keep bulbs out of the reach of children.
Otherwise, they could damage the bulbs, for
example, and injure themselves.
Never use a bulb which has been dropped.
Such a bulb may break or even explode and
injure you.
Halogen bulbs are pressurized and can
explode when you change them, particularly
if they are very hot. You should therefore wear
eye protection and gloves when you are
changing them.
See also:
Blind Spot Assist
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from speeds of
approximately 20 mph (30 km/h). A warning ...
Setting the temperature in the rear
compartment using the rear control
panel
Turn the SmartKey to position 2 in the
ignition lock.
To increase/reduce: press rocker
switch 12 or 17 up or down.
Only change the temperature setting in
small increments. Start at 72 °F (22 ...
Windows fogged up on the inside
Activate the cooling with air
dehumidification function via COMAND.
Activate automatic mode .
If the windows continue to fog up, activate
the defrosting function
You should only select this ...
