Automatic locking feature

The vehicle locks automatically when the ignition is switched on and the wheels of the vehicle are turning at a speed of more than 9 mph (15 km/h).

You could therefore be locked out when:
• the vehicle is being pushed.
• the vehicle is being towed.
• the vehicle is being tested on a dynamometer.

To deactivate: press and

hold button 1 for about five seconds until a tone sounds. To deactivate: press and hold button 1 for about five seconds until a tone sounds.
button 2 for about five seconds until a tone sounds. To activate: press and hold button 2 for about five seconds until a tone sounds.

buttons and If you press one of the two buttons and do not hear a tone, the relevant setting has already been selected.

You can also switch the automatic locking function on and off using the on-board computer.

    See also:

    Activating/deactivating the residual heat function
    The residual heat function is only available in Canada It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the ...

    Removing the mechanical key
    Removing the mechanical key Push release catch 1 in the direction of the arrow and at the same time, remove mechanical key 2 from the SmartKey. ...

    Activating audio AUX mode
    When you connect an external audio source, audio AUX is not selected automatically. Select Audio in the main function bar by sliding and turning the COMAND controller and press to confirm. ...