Switching on Night View Assist Plus

Depending on your vehicle's date of manufacture, the symbol for or the "Automatic driving lights/daytime running lamps" position is located on the symbol for the "Automatic driving lights/daytime running lamps" position is located on the light switch.

You can only activate Night View Assist Plus

You can only activate Night View Assist Plus if:
- the SmartKey is in position 2 in the ignition lock.
- it is dark.
- the light switch is set to either or, . or - reverse gear has not been engaged..

- reverse gear has not been engaged.

– Make sure that COMAND is switched on.
– Press button 1.
The Night View Assist Plus display appears in the COMAND display.

1 Night View Assist Plus display

1 Night View Assist Plus display
2 Pedestrian recognized
3 Framing
4 Symbol for active pedestrian recognition

You can read about how to adjust the brightness of the COMAND display in the COMAND operating instructions.

The infrared lamps switch on The infrared lamps switch on automatically from a speed of about 6 mph (10 km/h). This means that you do not have the full visual range while the vehicle is stationary and cannot check whether Night View Assist Plus is working.

    See also:

    Warning and indicator lamps
    High-beam headlamps ESP® OFF Low-beam headlamps Turn signal ESP® Turn signal ear fog lamp Tire pressure monitor (USA only) SRS ABS Seat belt Front fog lamps Coolant Brak ...

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the bod ...

    EASY-PACK folding floor with stowage compartment under the trunk floor (Wagon)
    Important safety notes WARNING Do not carry unsecured objects under the EASY-PACK folding luggage-compartment floor if it is open. Otherwise, you and other vehicle occupants could be inju ...