Warning and display messages in the multifunction display

Mercedes-Benz M-Class / Mercedes-Benz M-Class Owners Manual / Driving and parking / Driving systems / ATTENTION ASSIST / Warning and display messages in the multifunction display

– Activate ATTENTION ASSIST using the onboard

– Activate ATTENTION ASSIST using the onboard computer (Y page 232).
Symbol 1 appears in the multifunction display.

– If necessary, take a break.
– Press to confirm the or message. to confirm the message.

On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.

ATTENTION ASSIST is reset when you continue your journey and starts assessing your tiredness again if:
- you switch off the engine.
- you take off your seat belt and open the driver's door, e.g. for a change of drivers or to take a break.

    See also:

    Introduction
    You can establish a Bluetooth® connection to COMAND (see the separate operating instructions). WARNING A driver's attention to the road must always be his/her primary focus when driving. For ...

    ADS (Adaptive Damping System)
    General notes ADS adapts the damping characteristics to the current operating and driving situation. This depends on: - your driving style - the road surface conditions - the ADS setting - the ...

    Snow chains
    For safety reasons, Mercedes-Benz recommends that you only use snow chains that have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality. ...