Activating/deactivating the rear view camera

– To activate: make sure that the SmartKey is in position 2 in the ignition lock.
– Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for COMAND).
– Engage reverse gear.
The area behind the vehicle is shown in the COMAND display with guide lines.

– To change the function mode: using the

– To change the function mode: using the COMAND controller, select symbol 1 for the "Reverse parking" function or symbol 2 for the "Coupling up a trailer" function. See the separate COMAND operating instructions.

The symbol of the selected function is highlighted.

To deactivate: the rear view camera is deactivated when you:
- shift the transmission to position P
- drive forward ten meters
- shift the transmission from position R to another position (after 15 seconds)
- drive forward faster than 5 mph (10 km/h)

    See also:

    Cleaning the exhaust tail pipes
    Impurities combined with the effects of road grit and corrosive environmental factors may cause flash rust to form on the surface. You can restore the original shine of the exhaust tail pipe b ...

    Opening
    Press the button on the SmartKey. Pull handle 1. Raise the tailgate. Vehicles with the EASY-PACK tailgate: if you pull handle 1 and keep it in this position, you can open the tailga ...

    Crash-responsive emergency lighting
    The interior lighting is activated automatically if the vehicle is involved in an accident. To switch off the crash-responsive emergency lighting: press the hazard warning lamp button. or Loc ...