ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the
alarm system is armed and you open:
• a door
• the vehicle with the mechanical key
• the trunk lid
• the hood
The alarm is not switched off, even if you close the open door that has triggered it, for example.
If the alarm stays on for more
than 30
seconds, the emergency call system
mbrace (USA only) or TELE AID (Canada
only) initiates a call to the Customer
Assistance Center automatically. The
emergency call system initiates the call
provided that:
• you have subscribed to the mbrace/TELE AID service.
• the mbrace/TELE AID service has been activated properly.
• the required mobile phone, power supply and GPS are available.
To arm: lock the vehicle
with the SmartKey or KEYLESS-GO.
Indicator lamp 1 flashes. The alarm system is armed after approximately 15
seconds.
To deactivate: unlock the
vehicle with the SmartKey or KEYLESS-GO.
To stop the alarm using the
SmartKey:
insert the SmartKey into the ignition lock. The alarm is switched off.
or
Press the
or
button on the SmartKey.
The alarm is switched off.
To stop the alarm using
KEYLESS-GO:
grasp the outside door handle. The SmartKey must be outside the vehicle.
The alarm is switched off.
or
Press the Start/Stop button on
the dashboard. The SmartKey must be inside the vehicle.
The alarm is switched off.
See also:
Resetting
Reset the sliding sunroof if it does not move
smoothly.
- Turn the SmartKey to position 1 or 2 in the
ignition lock.
- Raise the sliding sunroof fully at the rear.
- Keep the
switch pressed ...
Resetting to factory settings
For safety reasons, the Day Lights function
in the Lights submenu is only reset when the
vehicle is stationary.
•► Press the button on the
steering wheel to select the Settings
menu.
...
Problems with the windshield wipers
The windshield wipers are obstructed
Leaves or snow, for example, may be
obstructing the windshield wiper movement.
The wiper motor has been deactivated.
•► For safety reasons, you should r ...