Floormat on the driver's side
WARNING 
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
► Slide the seat backwards.
► To install: place the floormat in the
footwell.
► Press studs 1 onto retainers 2.
► To remove: pull the floormat off
retainers 2.
► Remove the floormat.
See also:
Brow of hill
When driving up an uphill gradient, slightly reduce pressure on the accelerator
immediately before reaching the brow of the hill. Use the vehicle's own impetus
to drive over the top of the hil ...
Notes for 4MATIC vehicles
Vehicles with 4MATIC must not be
towed
with either the front or the rear axle raised,
as doing so will damage the transmission.
If the vehicle has transmission damage or
damage to the front ...
Cargo tie-down rings
Observe the following notes on securing loads:
secure the load using the cargo tie down rings.
do not use elastic straps or nets to secure a load, as these are only intended
as an anti-slip p ...