Checking tire pressure electronically
- Make sure that the SmartKey is in position 2 () in the ignition lock.
- Press the or button on the steering wheel to select the Service menu.
- Press the or button to select Tire Pressure.
- Press the button. The current tire pressure for each wheel will be displayed in the multifunction display.
If the vehicle has been parked for longer than 20 minutes, the Tire pressures will be displayed after driving a few minutes message appears in the display.
After a teach-in period, the tire pressure monitor automatically recognizes new wheels or new sensors. If a clear allocation of the tire pressure values to the individual wheels is not possible, the Tire Pressure Monitor Active message is shown instead of the tire pressure display. The tire pressures are already being monitored.
If a spare wheel/emergency spare wheel is mounted, the system may continue to show the tire pressure of the wheel that has been removed for a few minutes. If this occurs, note that the value displayed for the position where the spare tire is mounted is not the same as the spare wheel/emergency spare wheel's current tire pressure.
See also:
Controlling the rear-compartment
climate control automatically using the
rear control panel
Turn the SmartKey to position 2 in the
ignition lock.
Set the desired temperature.
To activate: press rocker switch 15 up or
down and select AUTO.
To deactivate: press rocker switch 15 up
...
Importing contacts automatically
If a mobile phone is connected to COMAND
via the Bluetooth® interface, the contacts
(phone book entries) of the mobile phone are
automatically imported into COMAND's
phone book.
Depending on ...
Service messages
Information on the type of service and service
intervals (see separate Service Booklet).
You can obtain further information from an
authorized Mercedes-Benz Center or at
http://www.mbusa.com (US ...