Checking tire pressure manually
To determine and set the correct tire pressure, proceed as follows:
- Remove the valve cap of the tire that is to be checked.
- Press the tire pressure gauge securely onto the valve.
- Read the tire pressure and compare it with the recommended value on the Tire and Loading Information placard on the B-pillar on the driver's side of your vehicle.
- If necessary, increase the tire pressure to the recommended value ().
- If the tire pressure is too high, release air by pressing down the metal pin in the valve using the tip of a pen, for example. Then check the tire pressure again using the tire pressure gauge.
- Screw the valve cap onto the valve.
- Repeat these steps for the other tires.
See also:
Restarting the tire pressure monitor
WARNING
It is the driver's responsibility to set the tire
pressure to the recommended cold tire
pressure. Underinflated tires affect the ability
to steer or brake the vehicle. You might los ...
Cargo tie-down rings
Observe the following notes on securing
loads:
• secure the load using the cargo tie down
rings.
• do not use elastic straps or nets to secure
a load, as these are only intended as an
anti-s ...
Glare from the side
Fold down the sun visor.
Pull the sun visor out of retainer 2.
Swing the sun visor to the side.
Pull or push the sun visor in the direction of the arrow.
...