Calibrating the compass

  • Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.

In order to calibrate the compass correctly, observe the following points:

  • calibrate the compass in the open and not in the vicinity of steel constructions or highvoltage transmission lines.
  • switch off electrical consumers, for example, the climate control, windshield wipers or rear window defroster.
  • close all doors and the tailgate.
  • Switch the ignition on.
  • Press a round pin into opening 3() for approximately six seconds until the C symbol appears in compass display 2().
  • Drive a full circle at approximately 3 mph (5 km/h) to 6 mph (10 km/h). Once the calibration has been successfully completed, the current direction appears in compass display 2().
    See also:

    Cleaning the windows
    WARNING Before cleaning the windshield or wiper blades, switch off the windshield wipers and remove the SmartKey from the ignition lock. On vehicles with KEYLESS-GO, press the Start/Stop but ...

    Activating/deactivating Lane Keeping Assist
    You can use the Lane Keeping Assist function to activate/deactivate Lane Keeping Assist or Active Lane Keeping Assist. Press the or button on the steering wheel to select the DriveAssist ...

    Important safety notes
    WARNING If you tow the vehicle, you must use a rigid towing bar if:  - the engine is not running.  - there is a brake system malfunction.  - there is a malfunction in ...