Points to observe before use
The sockets can be used for accessories, e.g. lamps or mobile phone chargers with a maximum current draw of 180 W (15 A).
If you use the sockets for long periods when the engine is switched off, the battery may discharge.
- Turn the SmartKey to position 1 in the ignition lock.
An emergency cut-out ensures that the on-board voltage does not drop too low.
If the on-board voltage is too low, the power to the sockets is automatically cut.
This ensures that there is sufficient power to start the engine.
See also:
Storing a destination in the destination
memory
Note
This function also stores the destination in
the address book.
After destination entry
The destination has been entered and is
shown in the address entry menu.
Select Save by sliding a ...
Opening and closing
Overhead control panel
1 To raise
2 To open
3 To close
- Turn the SmartKey to position 1 or 2 in the
ignition lock.
- Press or pull the
switch in the
corresponding direction.
If you ...
Turn signals
1 High-beam headlamps
2 Right turn signal
3 High-beam flasher
4 Left turn signal
► To indicate briefly: press the
combination
switch briefly to the pressure point in the
direction of a ...