Activating/deactivating the residual heat function
It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.
The blower will run at a low speed regardless of the airflow setting.
If you activate the residual heat function at high temperatures, only the ventilation
will be activated. The blower runs at medium speed.
It is possible that the residual heat function may be activated automatically
an hour after the SmartKey is removed. The vehicle is then ventilated for 30 minutes
to dry the air-conditioning system.
- Turn the SmartKey to position 0 in the ignition lock or remove it.
- To activate: press the
button.
The indicator lamp in the button
lights up. - To switch off: press the
button. The indicator lamp in the
button goes out.
Residual heat is deactivated automatically:
- after about 30 minutes
- when the ignition is switched on
- if the battery voltage drops
- if the coolant temperature is too low
See also:
Storing and maintaining the current speed
You can store the current speed if you are driving faster than 20 mph (30 km/h).
Accelerate the vehicle to the desired speed.
Briefly press the cruise control lever up 1 or down 2.
Remove your ...
Operating the on-board computer
The on-board computer is activated as soon
as you turn the SmartKey to position 1 in the
ignition lock.
You can control the multifunction display and
the settings in the on-board computer using
...
Precise wheel location: the front axle with McPherson struts
At the front axle a three-link construction with McPherson struts is used.
The lower link level consists of two separate elements which act as torque and
cross struts and which are both forged fro ...