Low-beam headlamps (halogen headlamps)

  • Switch off the lights.
  • Open the hood.
  • Remove the headlamp cover ().
  • Left-hand headlamp: detach the washer fluid reservoir ().
  • Turn housing cover 1 counter-clockwise and pull it out.
  • Pull connector 2 from bulb 4.
  • Unclip retaining spring 3 and fold it down.
  • Pull out bulb 4.
  • Insert the new bulb.
  • Clip retaining spring 3 back in.
  • Attach connector 2 to bulb 4.
  • Attach housing cover 1 and turn it clockwise until it engages.
  • Left-hand headlamp: fasten the washer fluid reservoir ().
  • Install the headlamp cover ().
    See also:

    Automatic car wash
    WARNING Braking efficiency is reduced after washing the vehicle. This could cause an accident. For this reason, you must drive particularly carefully after washing the vehicle until the brak ...

    Vehicle identification number (VIN)
    The vehicle identification number (VIN) can be found in the following locations: • on the vehicle identification plate • at the lower edge of the windshield In addition to being stamped on the veh ...

    Important safety notes
    DSR assists you when driving downhill. It keeps the speed of travel at the speed set on the on-board computer. The steeper the downhill gradient, the greater the DSR braking effect on the vehi ...