Removing and installing rear head restraints

WARNING WARNING

Occupants should only travel sitting on seats which have the head restraints installed. In the event of an accident, this reduces the risk of injury for passengers seated in the rear compartment.

  • To remove: pull the head restraint up to the stop.
  • Press release catch 1 and pull the head restraint out of the guides.
  • To re-install: insert the head restraint so that the notches on the bar are on the left when viewed in the direction of travel.
  • Push the head restraint down until you hear it engage in position.
    See also:

    Activating/deactivating DSR
    Activating DSR can only be activated if you are driving no faster than 20 mph (30 km/h). Vehicle without the Off-Road Pro Engineering package Vehicle with the Off-Road Pro Engineering package ...

    Storing the current speed or calling up the last stored speed
    WARNING The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from ...

    Real-time traffic reports on the map
    COMAND can show certain traffic incidents on the map. The incidents are shown on the map at a scale from 1/16 mi to 20 mi. Set the map scale. 12 Icon display for the section of route affected ...