Opening and closing

Overhead control panel

Overhead control panel

  1. To open
  2. To open
  3. To close
  4. Turn the SmartKey to position 1 or 2 in the ignition lock.
  5. Press or pull the in the corresponding direction. switch in the corresponding direction.

the point of resistance, an automatic opening/ closing process is started in the If you press the the point of resistance, an automatic opening/ closing process is started in the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Lowering the vehicle
    WARNING Vehicles with a spare wheel with a collapsible spare wheel only: do not inflate the collapsible spare wheel until it has been mounted. Inflate the collapsible spare wheel using the ...

    Qualified specialist workshop
    An authorized Mercedes-Benz Center is a qualified specialist workshop. It has the necessary specialist knowledge, tools and qualifications to correctly carry out the work required on your vehi ...

    Lights
    Display messages about LEDs: This display message will only appear if all LEDs have failed. Display messages Possible causes/consequences and •► Solutions Check Left Corneri ...