ATA (Anti-Theft Alarm system)

A visual and audible alarm is triggered if the alarm system is armed and you open:

  • a door
  • the vehicle with the mechanical key
  • the tailgate
  • the hood

The alarm is not switched off, even if you close the open door that has triggered it, for example.

(USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance If the alarm stays on for more than 30 seconds, the emergency call system mbrace (USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance Center automatically. The emergency call system initiates the call provided that:

  • you have subscribed to the mbrace/ TELE AID service.
  • the mbrace/TELE AID service has been activated properly.
  • the required mobile phone, power supply and GPS are available.

  • To arm: lock the vehicle with the SmartKey or KEYLESS-GO. Indicator lamp 1 flashes. The alarm system is armed after approximately 15 seconds.
  • To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
  • To stop the alarm using the SmartKey: insert the SmartKey into the ignition lock. The alarm is switched off.

or

  • Press the button on the SmartKey. or button on the SmartKey.

The alarm is switched off.

  • To stop the alarm using KEYLESS-GO:
    grasp the outside door handle. The SmartKey must be outside the vehicle. The alarm is switched off.

or

  • Press the Start/Stop button on the dashboard. The SmartKey must be inside the vehicle.
    The alarm is switched off.
    See also:

    Fogged up or dirty windshield
    If the windshield in front of the camera is fogged up or dirty on the inside or outside, the Night View Assist Plus display is affected. WARNING Please do not forget that your primary respons ...

    Vehicle
    Display messages Shift to P or N to start engine. Possible causes/consequences and ► Solutions You have attempted to start the engine with the transmission in position R or D. ► Sh ...

    Important safety notes
    WARNING For safety reasons, switch off the windshield wipers and remove the key from the ignition lock before changing the wiper blades (vehicles with KEYLESS-GO: make sure that the on-boar ...