System self-test

The you: indicator lamp illuminates when you:

  • turn the SmartKey to position 1 or 2 in the ignition lock
  • on vehicles with KEYLESS-GO, press the Start/Stop button once or twice

If an adult occupant is properly sitting on the passenger seat and the OCS classifies the occupant as an adult, the lamp illuminates and goes out again after approximately 6 seconds. indicator lamp illuminates and goes out again after approximately 6 seconds.

If the seat is not occupied and the OCS classifies the front passenger seat as being unoccupied, the will illuminate and not go out. indicator lamp will illuminate and not go out.

WARNING WARNING

If the the system is not functioning. You must contact an authorized Mercedes-Benz Center indicator lamp does not illuminate, the system is not functioning. You must contact an authorized Mercedes-Benz Center before seating any child on the front passenger seat.

For more information, see "Problems with the Occupant Classification System" ().

WARNING WARNING

Never place anything between seat cushion and child seat (e.g. a pillow), since it reduces the effectiveness of the OCS. The underside and rear side child restraint system must be placed entirely on the seat cushion and the backrest of the front-passenger seat backrest.

If necessary, adjust the tilt of the passenger seat backrest.

An incorrectly mounted child seat could cause injuries to the child in case of an accident, instead of increasing protection for the child.

Follow the manufacturer's instructions for installation of child restraint systems.

    See also:

    Switching on DISTRONIC PLUS, storing the current speed and maintaining it
    Important safety notes WARNING The vehicle can be braked when DISTRONIC PLUS is activated. For this reason, deactivate DISTRONIC PLUS if the vehicle is to be set in motion by other means ( ...

    Tire labeling overview
    The following markings are on the tire in addition to the tire name (sales designation) and the manufacturer's name: Uniform tire Quality Grading Standard () DOT, Tire Identification Num ...

    Deactivating/activating the ECO start/stop function
    General information You can deactivate and activate the ECO start/stop function using COMAND. You can also use the programmable button to activate and deactivate the ECO start/stop function i ...