Snow chains
For safety reasons, Mercedes-Benz recommends that you only use snow chains which have been specially approved for your vehicle by Mercedes-Benz, or are of a corresponding standard of quality.
You must drive at raised vehicle level if
snow chains have been mounted. The
vehicle could otherwise be damaged.
There is not enough space for snow
chains on some wheel sizes. Observe the
information under "Tires and wheels" in the
"Technical Data" section to avoid damage
to the vehicle or the wheels.
• Only use snow chains when driving on roads completely covered by snow. Do not exceed the maximum permissible speed of 30 mph (50 km/h). Remove the snow chains as soon as possible when you are no longer driving on snow-covered roads.
• Local regulations may restrict the use of snow chains. Applicable regulations must be observed if you wish to mount snow chains.
• Snow chains must not be mounted on emergency spare wheels.
If you intend to mount snow chains, please bear the following points in mind:
• you may not attach snow chains to all wheel-tire combinations; see the information under "Wheel and tire combinations" in the "Wheels and tires" section.
• mount snow chains only in pairs and only to the rear wheels. Observe the manufacturer's installation instructions.
If snow chains are mounted on the front
wheels, the snow chains could grind
against the bodywork or components of the
chassis. This could result in damage to the
vehicle or the tires.
Vehicles with steel wheels: if you wish
to mount snow chains on steel wheels,
make sure that you remove the respective
wheels' hubcaps first. The hubcaps may
otherwise be damaged.
You may wish to deactivate
ESP® when pulling away with
snow chains mounted. This way you can
allow the wheels to spin in a controlled
manner, achieving an increased driving
force (cutting action).
See also:
Activating/deactivating Blind Spot
Assist
You can use the Blind Spot Asst. function
to activate or deactivate Blind Spot Assist
(Y page 198) or Active Blind Spot Assist.
– Press or
on the steering wheel
to select the DriveAssist men ...
Selecting the screen for the remote control
Turn thumbwheel 3 until the desired
display is highlighted in the window. ...
Activating/deactivating Lane Keeping
Assist
You can use the Lane Keep. Asst. function
to activate/deactivate Lane Keeping Assist
(Y page 200) or Active Lane Keeping Assist.
– Press the or
button on the
steering wheel to select the Dri ...
