Fuse box on the right in the direction of travel
Open the hood.
Remove any existing moisture from the fuse box using a dry cloth.
To open: open clamps 2.
Remove cover 2 upwards.
To close: check whether the rubber seal is lying correctly in cover 2.
Put cover 2 back in position.
Fold down cover 1 and close clamps 2.
The cover must be seated properly, otherwise moisture or dirt could impair the function of the fuses.
Close the hood.
See also:
System self-test
After you have switched on the ignition, the
system carries out a self-diagnosis.
WARNING
A malfunction in the system has been
detected if one of the following conditions
occurs:
• t ...
Introduction
The Sett. menu can be used for:
• changing the instrument cluster settings
• changing the light settings
• changing the vehicle settings
• changing the convenience settings
• restoring the fact ...
EBD (electronic brake force
distribution)
Observe the "Important safety
notes"
section.
EBD monitors and controls the brake
pressure on the rear wheels to improve
driving stability while braking.
WARNING
If EBD has malf ...