Preparing the vehicle
Your vehicle may be equipped with a "Minispare" emergency spare wheel or MOExtended tires (tires with run-flat properties).
Vehicle preparation is not necessary on
vehicles with MOExtended tires.
Stop the vehicle as far away as possible
from traffic on solid, non-slippery and level
ground.
Switch on the hazard warning lamps.
Engage the electric parking brake manually.
Bring the front wheels into the straightahead
position.
Move the DIRECT SELECT lever to P.
Switch off the engine.
Vehicles without KEYLESS-GO: remove
the SmartKey from the ignition lock.
Vehicles with KEYLESS-GO: open the
driver's door.
The on-board electronics have status 0, which is the same as the SmartKey having been removed.
Vehicles with KEYLESS-GO: remove the
Start/Stop button from the ignition lock.
All occupants must get out of the vehicle.
Make sure that they are not endangered as they do so.
Make sure that no one is near the danger
area while a wheel is being changed.
Anyone who is not directly assisting in the wheel change should, for example, stand behind the barrier.
Get out of the vehicle. Pay attention to
traffic conditions when doing so.
Close the driver's door.
See also:
Points to observe before use
The sockets can be used for accessories, e.g.
lamps or mobile phone chargers with a
maximum current draw of 180 W (15 A).
If you use the sockets for long periods when
the engine is switched off, ...
Automatic transmission
Shift the transmission to
position P. The transmission position display in the
multifunction display shows P.
You can also start the engine
when the
transmission is in position N. ...
Driving safety systems overview
In this section, you will find information about
the following driving safety systems:
- ABS (Anti-lock Braking System)
- BAS (Brake Assist System)
- BAS PLUS (Brake Assist System Plus*)
- ESP® ...
