High-beam spot lamp (vehicles with halogen daytime running lamps)
Switch off the lights.
Open the hood.
Turn housing cover 1 counter-clockwise
and pull it out.
Turn bulb holder 2 counter-clockwise and
pull it out.
Take the bulb out of bulb holder 2.
Insert the new bulb into bulb holder 2.
Insert bulb holder 2.
Left-hand headlamp: cable outlet 3 must be pointing up and to the right.
Right-hand headlamp: cable outlet 3 must be pointing down and to the left.
Turn bulb holder 2 clockwise.
Handle 4 of bulb holder 2 is horizontal.
Align housing cover 1 and turn it
clockwise until it engages.
See also:
Search & Send
"Search & Send" is a destination entry
service. You can find further information on
"Search & Send" in the separate COMAND
operating instructions. ...
Engine oil viscosity
Viscosity describes the flow characteristics
of a fluid. If an engine oil has a high viscosity,
this means that it is thick; a low viscosity
means that it is thin.
Select an engine oil with an ...
Cross bar
Points to observe before use
The maximum roof load that can be used with
additional accessories decreases by the dead
weight of the crossbars (13.7 lbs/6.2 kg).
Note that installing the crossb ...