Switching locator lighting on/off

If you switch on the locator lighting, the following come on in the dark after you have unlocked the vehicle using the remote control:
• the parking lamps
• the tail lamps
• the license plate lamp
• the front fog lamps
• the entry lamps in the exterior mirror

The locator lighting switches off again when you open the driver’s door. If you do not open the driver’s door, the locator lighting switches off automatically after 40 seconds.

To switch locator lighting on/off: select

Vehicle in the main function bar by sliding To switch locator lighting on/off: select Vehicle in the main function bar by sliding the COMAND and turning controller and press  to confirm. the COMAND controller and press The main area is active. to confirm.

The main area is active.

sliding  or turning Select the Locator Lighting function by sliding the COMAND or turning controller and press  to confirm. the COMAND controller and press Switching the automatic locking to confirm.

    See also:

    Blind Spot Assist
    Important safety notes Blind Spot Assist uses a radar sensor system to monitor the areas on both sides of your vehicle. It supports you from speeds of approximately 20 mph (30 km/h). A warning ...

    SAFETY
    This is where I get back to overlooking those interior quirks because I'm so impressed by the R350's safety features. All of the seat belts in the second and third rows were easy for newbies to op ...

    Important safety notes
    WARNING Always remember that you must concentrate primarily on driving the vehicle. The driver's concentration must always be directed primarily at road traffic. For your own safety and t ...