Switching the ECO function on/off

The ECO start/stop function switches the engine off automatically if the vehicle is stopped under certain conditions. When pulling away again, the engine starts automatically. You can switch the ECO start/stop function on and off using COMAND.

If you switch the ECO start/stop function off using COMAND, the function is switched on again automatically when you switch the ignition off and on again.

To switch the ECO start/stop function

on/off: select Vehicle in the main To switch the ECO start/stop function on/off: select Vehicle in the main function bar by sliding the COMAND controller and press and turning to confirm. the COMAND controller and press The main area is active. to confirm.

The main area is active.

or Select the ECO function by sliding turning the COMAND controller and or turning press to confirm. the COMAND controller and press The ECO start/stop function is switched on to confirm.

The ECO start/stop function is switched on and off alternately.

    See also:

    Safety guidelines for seat belts, Emergency Tensioning Devices (ETDs) and air bags
    WARNING • Damaged seat belts or seat belts that have been subjected to stress in an accident must be replaced. Their anchoring points must also be checked. Only use seat belts installed or ...

    Reporting malfunctions relevant to safety
    For the USA only: The following text is reproduced as required of all manufacturers according to Title 49, Code of U.S. Federal Regulations, Part 575 pursuant to the National Traffic and Moto ...

    Reset function
    You can reset COMAND to the factory settings. Amongst other things, this will delete all personal data (e.g. station presets, address book entries, entries in the destination memory and in the ...