Operation with an active COMAND source
You can transfer an audio or video mode selected in COMAND to the Rear Seat Entertainment System.
If you subsequently switch modes in
COMAND, the new source will not be
transmitted to the Rear Seat Entertainment
System.
To switch on the function in COMAND:
switch on the desired audio mode in
COMAND or show the menu in video DVD
mode.
Select the menu item at the bottom left,
e.g. CD in audio CD mode, by sliding
and turning 
the COMAND controller
and press 
to confirm.
Select Active Source for Rear and
press 
to confirm.
In the status bar at the top, you will see the
headphones icon and the 
icon for
the
source that has been switched on.
To switch off the function in COMAND:
switch on the desired audio mode in
COMAND or show the menu in video DVD
mode.
Select the menu item at the bottom left,
e.g. CD in audio CD mode, by sliding
and turning 
the COMAND controller
and press 
to confirm.
Select Rear OFF
and press
the
COMAND controller to confirm.
See also:
Active Blind Spot Assist
Important safety notes
Active Blind Spot Assist uses a radar sensor
system to monitor the side areas of your
vehicle which are in back of the driver. A
warning display in the exterior mirrors d ...
Occupant distribution
The distribution of occupants in a vehicle at
their designated seating positions. ...
Notes on using dual-zone automatic climate control
The following contains notes and
recommendations on optimum use of dualzone
automatic climate control.
• Activate climate control using the
and
buttons. The indicator lamps in the
and
but ...