Setting the map scale

the COMAND To hide the menu: slide the COMAND the COMAND controller and, when the Full screen menu item is shown, press To call up the scale bar: as soon as you.

turn To call up the scale bar: as soon as you turn the COMAND controller, scale the COMAND controller, scale bar 3 appears.

until the desired scale is set. Turn until the desired scale is set. until the desired scale is set.

1 Set map scale as a number with unit

1 Set map scale as a number with unit
2 Currently set map scale as indicated by the needle on the scale bar
3 Scale bar

Unit of measurement 1 in the COMAND display depends on the selection made for the instrument cluster.

    See also:

    Useful information
    This Operator's Manual describes all models and all standard and optional equipment of your vehicle available at the time of publication of the Operator's Manual. Country-specific differences are ...

    Important safety notes
    ATTENTION ASSIST helps you during long, monotonous journeys such as on freeways and interstate highways. It is active in the range between 50 mph (80 km/h) and 112 mph (180 km/h). If ATTENTIO ...

    Notes for 4MATIC vehicles
    Vehicles with 4MATIC must not be towed with either the front or the rear axle raised, as doing so will damage the transmission. If the vehicle has transmission damage or damage to the fron ...