Avoiding a section of the route blocked by a traffic jam
This function blocks a section of the route ahead of you. You can set the length of the blocked route section. If possible, COMAND calculates a detour around the blocked section of the route.
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Route in the navigation system menu bar by turning the COMAND controller and press to confirm.
Select Detour and press to confirm.
To block a section of the route: select More or Less repeatedly and confirm using until the desired section has been selected.
The total length of the section that can be blocked is defined by the digital map. The menu items are available accordingly.
To start route calculation: select Start and press to confirm.
To delete the blocked section: select Delete while the message is shown and press to confirm.
COMAND calculates the route without the block.
See also:
Vehicles with a "Minispare" emergencyspare wheel
► Lift the trunk floor up.
1 Alignment bolt
2 Towing eye
3 Lug wrench
4 Ratchet wrench
5 Velcro fastener
6 Jack
7 Wheel bolts
8 Folding wheel chock
9 Fuse allocation chart
10 Stowage ...
Checking tire pressure electronically
Make sure that the SmartKey is in position
2 in the ignition lock.
Press the
or
button on the
steering wheel to select the Service
menu.
Press the
or
button to sel ...
Unlocking and opening doors from the inside
Only open the door when the traffic situation permits.
If the vehicle was previously locked with the SmartKey or with KEYLESS-GO, opening
the vehicle from the inside will activate the antitheft ala ...